TM 5-3895-374-107.Drum Mixer Tear Down Procedures(See Figures 2-12 and 2-15)ItemProcedure1Disconnect all control and power cables and store on brackets provided.2Using a crane remove the bypass chute and store for transport.3Using a crane to support the exhaust duct, remove the bolts at theplenum.4Lift the section of exhaust duct to the ground. The two pieces of steelduct can be unbolted. They both get stored on the generator trailer fortransport.5Remove the rubber seals from the duct joints and store for transport inthe control van. (Wipe clean prior to storage.)6Remove the ducting support leg and store.7Disconnect the exhaust plenum and rotate into the transport position.Secure with bolts.8Remove the rubber seals from the duct joints and store for transport inthe control van. (Wipe clean prior to storage.)9Connect the hydraulic power pack. Connect power cable and start pumpmotor.10Raise the trailer using the hydraulic levelling jacks so that the weight isremoved from the screw jacks.11Remove the pads from the screw jacks and stow the pads and legs in thetransport position.12Bolt the landing jacks into the operating position. Extend the jacks totheir maximum length.13Fully retract the hydraulic levelling jacks lowering the trailer. The trailerwill be supported by the wheels and landing legs.14Disconnect the hydraulic power pack.15Connect the transport tractor and move the drum mixer as desired.page 2 - 63
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
