TM 5-3895-374-10ItemProcedure17Secure the top set first by retracting the lower cylinders. If the chassis isnot level the conveyor frame may not slide between these two tabs.18Push the conveyor frame sideways so that it will fit between the transportlugs. If unable to accomplish this the chassis may need to be levelled.Disconnect the hydraulic power pack from the conveyor control valve andconnect it to the levelling jack control valve. Level the rear of the chassisso that the gathering conveyor will fit between the transport lugs. Re-connect the hydraulic power pack back to the gathering conveyor controlvalve.19After final position is obtained secure the conveyor into place with the fourtransport bolts.20Connect the power pack to the hydraulic level jacks.21Use the hydraulic levelling jacks to relieve pressure from the screw jacks.22Remove the base pads from the screw jacks and install in the transportposition.23Position the screw jacks in the transport position.24Lower the trailer by retracting the levelling jacks.25Disconnect the hydraulic power pack.26Connect the transport tractor and move the four bin feeder as desired.3.Feed Conveyor Tear Down Procedures(See Figure 2-22)ItemProcedure1Ensure feed conveyor is empty of all aggregate.2Disconnect all control and power cables and store on brackets provided.3Secure the screen to the screen deck by using the red transport plates.Bolt the four plates into the transport position.4Locate the hydraulic power pack and connect the hydraulic lines to theconveyor control valve. Connect power cable and start the pump.5Disconnect the conveyor by removing the pins securing the conveyor tothe support structure.page 2 - 58
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
