The purge process has been activated and the air in the drum and baghouse is being exhausted.

These units should run for a minimum of 15 minutes to warm up both conveyors

The purge process has been activated and the air in the drum and baghouse is being exhausted. - TM-5-3895-374-10_139

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
128

TM 5-3895-374-10 No. Panel Value Operation 34 B Motor control panel-press the Baghouse Airlock START button (light will illuminate). 35 B Motor control panel-press the Baghouse Discharge Incline Screw START button (light will illuminate. 36 B Motor control panel-press the Baghouse Transfer Screw START button (the light will illuminate). 37 B Motor control panel-press the Baghouse Hopper Screws START button (all four screws will start). NOTE A steady illuminated light will indicate that all four screws are running. A flashing light indicates that one or more did not start. (Panel B) 38 B Motor control panel-select AUTO on the Baghouse Clean switch (light will illuminate when cleaning is in progress during mixing process). 39 D Burner control panel-press START on Fuel Pump (light will illuminate). 40 D < 300 F Burner control panel-observe the stack temperature is below the high (alarm) set point Stack Control. 41 D Burner control panel-if "limits" are closed PRESS Limits Set (this button will light). NOTE The purge process has been activated and the air in the drum and baghouse is being exhausted. 42 D Burner control panel-upon completion of the purge, the purge complete light will illuminate. 43 D Burner control panel-DEPRESS the Pilot button and hold until the pilot is on (approximately 5 to 10 seconds- the pilot on light will illuminate). Page 2-104

Privacy Statement
Press Release
Contact