TM 5-3895-374-24-1
Commissioning terminal
When the speed controller Is switched on or the terminal Is connected up, the speed controller’s
Identification appears on the screen.
Example:
ATV452
15kW
Identification - Rating
380/415U
V1.1
Mains supply - Software version
If the autotest has been selected (AUTOTEST switch on the dialogue unit in position ON when
switched on), the Identification of the speed controller is followed by the messages:
Autotest
then
Drive
Running
Healthy
or signals
a fault, for example
Trans short-circ
-1-
Selection of the
Identification of the speed controller once displayed on the screen, press the key CLR
language
It Is now possible to select the dialogue language English - French - German - Italian -
Portuguese - Spanish by pressing keys successively
Validation of the language selected Is obtained by pressing the key ENT
Normal operation
Having chosen the language, or immediately after identification of the speed controller, access to
the terminal’s normal operation Is obtained by pressing ENT
The various messages which appear on the screen have four hierarchical levels
1) Electrical quantities
2) Choice of control or adjustment modes
3) Choice of the vanables to be modified
4) Modification of a vanable or a parameter
Electrical quantities
These appear in pairs, in 3 tables, movement from one table to another Is achieved by pressing
keys and .
- Setspeed and motor current.
- Thermal state of the motor and mains supply.
- Motor load and motor frequency.
Example:
SetsPeed 38.3Hz
Current 15.9R
(page 3-252)
