TM 5-3895-374-24-1Commissioning softwarePresentationThe compatible microcomputer software supplied with the ATV-45 2 provides all the variable speedcontroller configuration, adjustment and control possibilities which can be carried out with the Initialsetting up terminalIn addition, It enables- preparation of the job In the design office, without the ATV-45 2 being connected to the micro-computer- saving of configurations and adjustments on floppy disk or hard disk, as well as their down-loadingInto the speed controller- to provide a printout of documents which can be included In a contract fileThe software can be run on any microcomputer, with a minimum of the following features- a 3"1/2 disk drive- 256 K bytes RAM- a COM series communication port- a DOS operating system, version 3 1 minimumInitial setting UpThe ALTIVAR ATV-45 2 must be connected to the microcomputer’s COM port by RS232C serial linkusing a 10 metre cable, maximumFollow one of the connection diagrams shown below The COM port is on a SUB D 25 pin or SUB D9 pin connector, depending on the compatible microcomputer model(page 3-247)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
