TM 5-3895-368-14&P Figure 4-10.  Press-In Tool Details. (3) If   installing   a   new   stator   assembly   (20), install pin (21). (4) Carefully  install  the  stator  into  the  motor housing  (56,  Figure  4-4),  engaging  slot  in housing with pin (21, Figure 4-5). CAUTION When installing the centrifugal mechanism   (7),   do   not   allow   more than    3000    pounds    of    force    to    be applied.    Damage  may  result  should greater force be used. (5) Install spacer (8) on rotor shaft, and using tool   described   in   figure   4-10,   press   the centrifugal  mechanism  (7,  Figure  4-5)  on the rotor shaft until seated  against  spacer (8) as shown in figure 4-11. NOTE Centrifugal mechanism must be installed     with     spring     loaded     side facing away from rotor windings. Figure 4-11.  Installing Centrifugal. (6) Install   the   capacitor   (17),   securing   with mounting spring (18) and screw (19). (7) Install  flat  washer  (15)  and  wave  washer (14)   in   housing   on   top   of   bearing   (23, Figure 4-4). (8) Install inner  retaining  ring  (12,  Figure  4-5) into inner groove of rotor shaft (11).  Install bearing (13) and outer retaining ring (12). (9) Carefully   install   the   rotor   assembly   (11) into  the  stator  assembly  (20),  seating  the rotor shaft into bearing (23, Figure 4-4). (10) Referring to tags noted during disassembly   and   wiring   diagram   (Figure 4-8), make all electrical connections  while installing    the    assembled    cover    to    the motor housing. (11) With  rotor  shaft  seated  into  the  splines  of the shaft (35, Figure 4-4), secure cover (4, Figure 4-5) with screws (1) and lockwashers (2).  Tighten screws (1) to 48 in-lbs torque. k.  Assembly - Brake End (Figure 4-3). (1)   If   removed,   install   coil   (7)   to   field   (8); securing with strap (9). (2) Install  brake  plate  (1)  and  a  friction  plate (2) over studs of frame assembly and seat into housing. NOTE When  installing  the  friction  plates  (2 and  4),  always  install  with  wide  side of pads facing the brake hub (39) and the pads facing the brake discs (3). (3) Install  a  brake  disc  (3),  engaging  splines of  brake  hub,  friction  plate  (4)  a  second brake  disc  (3)  and  a  second  friction  plate (2). 4-14