TM 5-3895-374-24-1
Chapter 5
Installing Your Hardware Components
This chapter shows you how to install the following hardware components:
your processor
modules
your memory module
your power supply
your chassis interconnect cable
Installing Your Processor
The processor always occupies the first slot of the first chassis. You can only
install one processor per system.
ATTENTION: Never install, remove, or wire any module while power
is applied. Also, do not expose processor modules to surfaces or
other areas that may typically hold an electrostatic charge.
Electrostatic charges can alter or destroy memory.
Important:
If your processor has a battery -- the battery is an option for the
SLC 5/01 (1747-L511) processor -- make sure it is connected
before installing your processor into the chassis. This provides
memory backup for your processor should the controller power
supply fail.
Installing Modules
The following explains how to install your modules.
1.
Align circuit board of the module with card guide in the chassis.
(Page 3-411)