TM 5-3895-374-24-1
Chapter 9
Troubleshooting
Troubleshooting MSG
When an error condition occurs with a Message Instruction (MSG), die error
Instruction Error Codes
code and its description are indicated in the APS Data Monitor display.
INSTRUCTION ERRORS
Error
Code
Fault Description
02H
Target node is busy The MSG instruction will automatically reload.
If other messages are waiting, the message is placed al the bottom
of the stack
03H
Target node cannot respond because message is too large
04H
Target node cannot respond because It does not understand the
command parameters
05H
Local processor Is offline.
06H
Target node cannot respond because requested function is not
available.
07H
Target node does not respond
08H
Target node cannot respond
09H
Local modem connection has been lost.
10H
Target node cannot respond because of incorrect command
parameters or unsupported command
11H
Local file has constant file protection
12H
Local channel configuration protocol error exists
13H
Local MSG configuration error in the Remote MSG parameters
14H
Local communication driver is Incompatible with the MSG
instruction
15H
Local channel configuration parameter error exists
16H
Target or Local Bridge address is higher than the maximum node
address
17H
Local service is not supported
18H
Broadcast (Node Address 155) is not supported
37H
Message timed out In local processor
50H
Target node is out of memory
60H
Target node cannot respond because file Is protected
F1H
Local processor detects illegal target file type
E7H
Target node cannot respond because length requested is too large
page 3-402
