TM 5-3895-374-24-1 Chapter 9 Troubleshooting TROUBLESHOOTING CONSIDERATIONS GENERAL ERROR SCREEN ATTEMPTED FUNCTION PROBABLE CAUSES RECOMMENDED ACTION The Maximum Node Address Of The Previous Node Is Lower Than The Module Address Change the maximum node address of the previous node Duplicate Node LED Flashing Red Module Has Same Node Address As a 5/02 or 5/03(Point-to- Point Connection) Change the module node address LED Flashing Red Module Has Same Node Address As Another Node(DH- 485 Network Connection) Change the module node address No Response LED Illuminated Green or Flashing Green The Node That The Module Is Attached To Has Too Many Other Nodes Trying To Communicate With It Decrease the network traffic to the desired node address XX Is inactive ? LED Illuminated Green or Flashing Green The Processor At That Node Address Is Not Powered Up Power up the processor The Processor At That Node Address Is Disconnected From The Network Activate that processor on the network. A Fault Has Caused That Processor Node Address To Change To a Default Of One Change the processor node address The Processor Is Set At The Wrong Baud Rate Change the processor baud rate XX Is not a CPU ? LED Illuminated Green or Flashing Green The Node Address You Are Attempting To Attach to Is a Programming Device Or Another DTAM Abort A Programming Device Has Been Connected To The Network With The Same Node Address As a Processor Change the node address of the programming device XX not supported ? LED Illuminated Green or Flashing Green The Node Address You Are Attempting To Attach To Is a Non-Supported Device Abort Contact your local Allen-Bradley sales office ? Where XX is the Node Address Value. page 3-400