TM 5-3895-374-24-2Accessories:DescriptionPart NumberEnclosure................National Controls offers NEMA-4 type enclosures for mountingour controls. These enclosures are made of heavy gauge steel andhave a continuous hinge type cover. All seams ore continuouslywelded. The finish is gray hammer-tone enamel inside and out overphosphatized surfaces.for T2003 ................8" x 6" x 3 ½".............................................................................................BOX-A0806-CHNFfor T2006 ................10" x 8" x 4"...............................................................................................BOX-A1008-CHNFfor T2010 ................10" x 8" x 4"...............................................................................................BOX-A1008-CHNFfor T2020 ................12 x 10" x 5" ..............................................................................................BOX-A1210-CHNFfor T2032 ................14" x 12" x 6".............................................................................................BOX-A1412-CHNFPilot Lamp...............NEMA-4 rated red light..............................................................................ASL-00RED-NEMA4On/Off Switch .........NEMA-4 rated switch with legend plate.....................................................MSWODPST-011Important Notice to UsersOur timers are capable of use in a wide array of devicesand in various applications.Any device or system incorporating a timer should be sodesigned that, in the event of failure, malfunction ornormal wear-out of the timer, the device or system willbecome inoperative in a manner which will preventproperty damage or bodily injury.To expand the number of outputs to 64 or less, anytwo timers can be connected via a dual coil alternateaction latch relay as shown.The output pulse from the last compartment used intimer 1 causes the latching relay to transfer to the “Aposition shown, thus stopping timer 1 and starting timer2. When the lost compartment used In timer 2 pulses,the reverse happens as the latching relay transfers toposition “B".Some Don’ts:1. Do not mount controls in high vibration areaswithout shock mounts.2. Do not mount controls in areas of high dust orcorrosive atmospheres without a protectiveenclosure.3. Do not use a converter or inverter for the powersource.4. Do not mount control in high transient voltageare as without an isolation transformer.5. Do not leave control box door open.6. Do not allow a local repair shop to repair thecontrols as we employ some very sophisticatedcomponents that could be further damaged. Forservice call us directly.(page 3-708)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
