TM 5-3895-374-24-2DESCRIPTIONThe Fireye EP260, EP261, and EP270 ProgrammerModules are used with the FLAME-MONITOR System.The operational characteristics of the burnermanagement system are determined by the selection ofthe programmer. These characteristics include timingfunctions, switching sequences and display messages.EP260, EP270, and EP261 provide start-upprogramming, safe-start check and flame monitoringsupervision. They incorporate a proof of low fire positioncircuit as well as fuel valve end switch safety checks. Arunning interlock circuit on the FLAME-MONITORsystem constantly monitors the limit switches, air flowswitches and fuel pressure switches.The programmer module will de-energize all fuel valvecircuits within four seconds following a flame failure or atthe end of the pilot trial for ignition period if no flame isdetected. An alarm circuit will be energized following asafety lockout. The Programmer will recycle following arunning interlock open circuit during a firing cycle.The Programmer is the heart of the FLAME-MONITORSystem and incorporates a plug-in design for ease ofinstallation. It is microprocessor based and stores theburner cycle and on-time history. If replaced, the newprogrammer card will begin accumulating a new history.Refer to Bulletin E-1001 for detailed information on theentire FLAME-MONITOR System.CAUTIONWhile all controls are mechanically interchangeable in that they mate with a common wiring baseyou should select the correct model for your application Inappropriate application of a controlcould result in an unsafe condition hazardous to life and property. Selection of a control for aparticular application should be made by a competent professional such as a Boiler/BurnerService technician licensed by a state or other government agency.(page 3 - 1067)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
