TM 5-3895-374-24-27. Electrical power supply7-1 Installation of power supply cable (PT and GT type)(1) Provide a messenger wire (3-6mm dia. wire) along the beam andhang the power supply cable without twisting it through thecable hangers.(2) Install the messenger wire as shown in Fig. 7. For PT andGT types, the wire should be located on the right side of thecable hanger arm of the hoist.Fig. 7•When the beam has a curve, messenger wire at the curve can notbe installed. A special T type cable hanger for the curvedbeam section is available upon request. Consult your localdealer for proper number of hangers and spacing between them asthey differ depending on the location and radius of the curvein the beam.•Also consult your local dealer in case the electrical powersupply is by means of other ways.7-2 Electrical wiringKito single phase hoist can be used on single phase electric powersource. Compared with conventional home electrical equipment, abig capacity's motor is used on the hoist. Consult your localelectrical workers for proper wiring of the single phase hoist.(page 3 - 886)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
