TM 5-3895-374-24-2 Section VII - Sectional Drawing Item Description Item Description Item Description 2 Casing 140 Gasket 230 Ball Bearing 3 Cover 163 Hex, Bolt 241 Sleeve Bearing 30 Impeller 170 Hex, Bolt 256 Key 40 Support Foot 171 Hex, Bolt 257 Key 80 Gasket 179 Hex, Nut 260 Retaining Ring 81 ’O’ Ring 180 Washer 266 Spacer 82 Plug - Plastic 181 Washer 286 Impeller Nut 83 Plug - Plastic 200 Shaft 292 Lock Washer 130 Vent Plug 210 Bearing Housing 295 Grease Fitting 131 Plug 221 Bearing Cover 400 Radial Seal Rings Radial Seal Ring Section VIII - Spare Parts A - Recommended Spare Parts Recommended    on-site    spare    parts    for    general service  for  approximately  one  year  of  service  are  the following: Item No. Description qty. 80 Gasket 1 230 Bearing 1 241 Sleeve Bearing 1 400 Radial Seal Ring 6 426 Radial Seal Ring 1 For  critical  service  it  is  recommended  that  a  spare pump or -back pull-out assembly’ be kept at hand.  This assembly  includes  all  the  parts  except  the  casing  and impeller. B - Ordering Spare Parts To    order    spare    parts    for    the    pump,    the    following information would be required: 1. Pump model number and serial number.  These can be found  on  the  pump  nameplate  located  on  the  bearing housing.  Be sure to include the impeller dimension if so indicated on the model number. (Example ZTNY5016/130  AN  .002.06.2,  the  130  is  the  impeller size). 2. Item   number,   description   and   quantity   of   the   parts required. 3. Complete shipping instructions. page 3 - 1148