TM 5-3895-374-24-1
Initial setting up
Modification of the
After changing the value of one of the parameters, turn the CONFIG switch to position 1 to
configuration
the list of parameters on page 42
parameters
The value of the configuration parameters is STORED in a permanent memory (EEPROM)
In the event the value of one of the parameters being changed, the new value is recorded
In the memory the moment the CONFIG switch is moved to position 1. If the variable
speed controller is switched off before the value has been recorded, the parameter
remains unchanged
List of the configuration parameters and the possible values
The preset values are marked with an asterisk *
The specific ATV-452???N (440/500 V) and ATV-452???S (525/575 V) values are marked
with 2 asterisks **
It may be necessary to eliminate the slip compensation for certain applications
- supply of synchronized asynchronous motors,
- fans, centrifugal pumps,
NOTE
If the speed controller is fitted with the VW3-A45503 optional communication board (p 78),
the Adr parameter (address) appears after the parameters above
Refer to the operators manual supplied with the option
(page 3-196)