Check the Load Cell Wiring Guide, for the colour code of your load cells.
If you are using only one scale or load cell, it must be connected to
channel 1. Additional scales may be connected to either Channel 2
Ensure that the Shield wire is not left bare when attaching it to the
terminal. Insulate the Shield wire with shrink tubing or tape to
prevent the possibility of it shorting to the circuit board.
Secure the load cell cables with the tie wraps provided.
WIRING OF LOAD CELLS - SLIMLINE MODELS
Connect load cells to the terminal board at the back of the indicator.
See fig. 4.
FIG. 4 LOAD CELL CONNECTOR BLOCK - SLIMLINE
Check the Load Cell Wiring Guide for the colour code of your cells.