TM 5-3895-374-24-2955-2571.14 REMOTE SETPOINT INPUTA controller with REMOTE SETPOINT input option provides for remote linear analog current or voltage control of theprimary setpoint. Although the standard setpoint input is calibrated for 0 to 5 VDC, other voltages through 10 VDC orcurrents through 100 mADC may be supplied on special order. The remote input may be from an isolated stablecurrent or voltage supply or, where the setpoint can be manually adjusted to the required value, it may use an internalcontroller supply with a remote potentiometer for a simplified source. All controllers supplied with remote setpoint inputoption have a part number whose second digit is a "1”.NOTE:Controllers with remote setpoint input option can not have an ALARM/TIMER 2 asthese terminals are used for the remote setpoint input.SPECIAL WIRING:The rear barrier terminal connections are changed as shown below. All other connections areas described in Section 1.1.15 DIGITALCOMMUNICATIONSWIRINGControllers with a digital communications option areprovided with a special Type D (DB25) connectorbetween the rear terminals. Wiring to this connectoris discussed in detail in Section 5.1.16 INITIALPOWERUPAfter all connections have been made to the rear terminal connections and the correct wiring verified, power may beapplied. The display should illuminate as soon as power is applied. If the multicolor vacuum fluorescent display doesnot illuminate immediately, disconnect the power and recheck the wiring. Allow at least 5 minutes for warm up beforestarting operation.ECLIPSE INSTRUMENTATION DIVISIONpage 3-1087
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
