TM 5-3895-374-24-1
GP322FF
16.
Connect the wiring in the junction box following the markings box.
17.
Install the drive belts onto the sheaves. Use the torque arm and tension the belts properly. Check the
alignment made at disassembly Place the cover on the junction of the sheaves and adjust If necessary.
18.
Install the belt drive guard.
19
Inspect all components that have been re-installed. Confirm that all fasteners have been torqued. Check
component alignment to determine that it is proper.
20.
Remove padlock from the breaker and turn breaker on.
21. Jog the drum drive motor a few times to confirm that everything appears to be running correctly Run the motor
for a short period and observe the drives. Recheck belt and chain tension and alignment.
page 3-561
