TM 5-3895-374-24-1
Initial setting up
The ALTIVAR ATV-45 2 is factory preset to meet the most common utilization
requirements The preset values are marked below with an asterisk *
The specific ATV-452.???.N and S values are marked with 2 asterisks **
Check that they are compatible with your requirements
If so, after checking the connections (see recommended circuit diagram, page 21), the
speed controller can be switched on
If not, readjust the settings
The setting controls are grouped on the front of the control board, and are accessible
without removing the front cover, but simply by lifting the protective flap
In order to modify the position of the C links, access to the control board must be obtained
For < 30 kW models undo the quarter turn fasteners, and open the cover from the left to
the right
For > 37 kW models remove the cover, fixed by captive screws
CAUTION do not touch the components
Layout of the
setting controls
(page 3-189)
