TM 5-3895-374-10
Item
Procedure
48
Remove the feed hopper from its transport position on the rear of the chassis and install it onto
the feed end of the slat conveyor.
NOTE
The surge bin air compressor may be used to power air wrenches for the balance of
the plant set up. Power to the air compressor Is obtained through the control panel.
Motor Control Center #2 - turn surge bin air compressor breaker to the on position.
Feeder panel - turn the power key to the on position.
Motor control panel - turn surge bin air selector switch to the on position.
page 2-19
