• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
FUEL REQUIREMENTS
POST INSTALLATION CEI SERVICE REQUIREMENTS

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  241    242    243    244    245  246  247    248    249    250    251  
TM 5-3895-374-24-2 POWER SUPPLY REQUIREMENTS ELECTRICAL POWER: Electrical  power  is  connected  to  the  circuit  breaker  in  the  main  control  panel.    Standard  voltage  is:  460 Volt/60 Cycle/3 Phase A.C.  or 230 Volt/6 Cycle/3 Phase A.C. Amperage supply shall be: At 230 Volts At 460 Volts Model CEI-500 30 Amps. 20 Amps. CEI-800 30 Amps. 20 Amps. CEI-1000 30 Amps. 20 Amps. CEI-1500 30 Amps. 20 Amps. CEI-2000 40 Amps. 30 Amps. CEI-3000 50 Amps. 40 Amps. CEI-4000 60 Amps. 50 Amps. WARNING Proper  voltage  and  frequency  is  mandatory.    Voltages  over  ten  percent  above  or  below  those stated can cause poor operation and damage to the equipment. A heater may be changed from 460 Volts/60 Cycle/3 Phase to 230 Volts/60 Cycle/3 Phase or vice versa by making the following changes: 1. Reconnect the burner motor to the desired voltage. 2. Reconnect the pump motor the desired voltage. 3. Reconnect the primary taps of the control transformer to the desired voltage. 4. Change  the  overload  heaters  on  the  burner  motor  starter  to  the  proper  current  rating  for  the  motor  at  the new voltage. 5. Change the overload heaters on the pump motor starter to the proper current rating for the motor at the new voltage. 6. Check   the   burner   motor   and   the   pump   motor   for   proper   rotation;   if   the   rotation   of   either   is   wrong, interchange any two of the three leads to that motor at the secondary side of the magnetic starter. page 3-926







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.