• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Installing and Replacing the Battery of the SLC 5/01 or 5/02 Processor
Replacing Your SLC 5/03 Battery - TM-5-3895-374-24-1_459

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  412    413    414    415    416  417  418    419    420    421    422  
TM 5-3895-374-24-1 Chapter 8 Maintaining Your Control System Replacing Your SLC 5/03 Your 5/03 processor provides back-up power for RAM through a replaceable Battery lithium battery This battery provides back-up for approximately 2 years. A BATT LED on the front of the 5/03 processor alerts you when the battery voltage has fallen below a threshold level To replace the 5/03 processor lithium battery follow these steps: ATTENTION: Do not remove the 5/03 processor from the SLC 500 chassis until all power is removed from the SLC 500 power supply 1. Remove power from the SLC 500 power supply. 2. Remove the 5/03 processor from the chassis by pressing the retainer clips at both the top ,and bottom of the module and slide it out. ATTENTION: Do not expose the 5/03 processor to surfaces or other areas that may typically hold an electrostatic charge Electrostatic charges can alter or destroy memory. 3. Unplug the battery connector. Refer to the figure below for battery connector location. Important: The 5/03 processor has a capacitor that provides at least 30 minutes of battery back-up while the battery is disconnected. Data in RAM is not lost if the battery is replaced within 30 minutes. (page 3-430)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.