• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Removing Damaged Retainer Clips
Troubleshooting

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  415    416    417    418    419  420  421    422    423    424    425  
TM 5-3895-374-24-1 Chapter 8 Maintaining Your Control System Replacing a Fuse on the Power To replace a fuse on the power supply, do the following: Supply 1. Remove power from the SLC 500 power supply 2. Open the door on the power supply and use a fuse puller to remove the fuse. ATTENTION: Use only replacement fuses of the type and rating specified for the unit. Improper fuse selection can result in equipment damage. 3. Install a replacement fuse See page 1-7 for replacements. See the figure below for fuse placement ATTENTION: The exposed pin on the 3-pin jumper is electrically live. Contact with the pin may cause injury to personnel. (page 3-433)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.