• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Using Removable Terminal Blocks (RTB)
Maintaining Your Control System

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  407    408    409    410    411  412  413    414    415    416    417  
TM 5-3895-374-24-1 Chapter 6 Wiring Your I/O Modules Installing RTBs Below are guidelines for installing the RTB. 1. Label the RTB properly. 2. Match the label identification to tie correct chassis, slot, and module    type. ATTENTION:  Inserting a wired RTB on an incorrect module can damage the I/0 module circuitry when power is applied. 3. Be sure the color band on the I/O module matches the color of the RTB. ATTENTION: Never Install or remove I/O modules or RTBs while the SLC 500 chassis is powered. 4. Remove power from the SLC 500 chassis. 5. Line up terminal block release screws. 6. Press the RTB firmly onto connector contacts. 7. Tighten the RTB release screws. (page 3-425)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.