• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Electrical Power Cables and Control Cables - TM-5-3895-374-10_92
Electrical Power Cables and Control Cables - TM-5-3895-374-10_94

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  78    79    80    81    82  83  84    85    86    87    88  
TM 5-3895-374-10 Item Procedure 6 Raise the conveyor to maximum height with the hydraulic cylinder. 7 Using the hydraulic lifting jacks raise the trailer so that all weight is removed from the screw jacks.  Remove the pads and store the pads and the legs. 8 Raise the front of the trailer using the levelling jacks. 9 Bolt the landing jacks into the transport position. 10 Retract all levelling jacks. 11 Disconnect the hydraulic power pack. 12 Connect the transport tractor to the trailer and pull the feed conveyor forward until the conveyor can be lowered without hitting the drum mixer. 13 Locate the hydraulic power pack and connect the hydraulic lines to the conveyor.  Connect power cable and start the pump. 14 Lower the conveyor into transport position and secure. 15 Replace the fifth wheel adapter if the adapter is to be used. 16 Disconnect the hydraulic power pack. 17 Connect the transport tractor and move the feed conveyor as desired. 4. Dedrummer/Melter Tear Down Procedures (See Figure 2-20) Item Procedure 1 Remove all asphalt from drum meter tank.  The asphalt should be transferred to a suitable transport vehicle. 2 Remove all diesel fuel from drum meter fuel tank.  The fuel should be transferred to a suitable transport/storage vehicle. 3 Disconnect the power cables and store on brackets provided. 4 Close all hot oil valves on both ends of lines connecting the drum meter and the asphalt tanker. page 2 - 59







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.