TM 5-3895-374-24-2
6.
Lubricate the piston, seals and cylinder bore and install piston and shaft into the cylinder.
7.
Using the face spanner wrench tighten the cylinder head into the cylinder tube until the outer face of the
cylinder head is flush with the end of the cylinder tube.
8.
Install the hydraulic cylinder onto the equipment and connect the hoses.
9.
Upon installation of the cylinder, completely extend and retract the cylinder under no load several times to
allow trapped air to escape through to the reservoir.
3-9-14 Belt Fasteners
See the following vendor data on the installation and use of conveyor belt splice and repair fasteners.
page 3-1338
