TM 5-3895-374-24-2
3-9-13 Hydraulic Cylinder
Repair and Re-assembly. See figure 3-69.
A.
Disassembly
1.
Remove hydraulic cylinder from the installation. Disconnect hose lines and cap hose ports to prevent both
loss of oil and contamination from entering the system. Drain the oil from the cylinder.
2.
Clean complete exterior of cylinder of all loose dirt and oil.
3.
Using suitable face spanner wrench remove the cylinder head. If the cylinder head does not turn easily do
not force it causing damage. The exterior of the cylinder tube may have to be heated around the thread
area to free the cylinder head.
4.
Withdraw the cylinder shaft with piston from the tube.
B.
Inspection
1.
Clean the components. Inspect internal tube and chrome rod for gouges, scratches or wear.
2.
Replace components that are damaged.
3.
Replace all seals.
C.
Assembly
1.
Lubricate the o-rings and seals prior to installation.
2.
Install the piston seals onto the piston.
3.
Install the seals into the cylinder head.
4.
Install cylinder shaft spacer tube, if required, onto shaft.
5.
Lubricate the bore of the cylinder head and slide it onto the cylinder shaft.
page 3-1336
