TM 5-3895-374-24-2
6.
Inspect the drive mount for damage or cracks to any of the welds. Repair as necessary.
7.
Inspect the blower line. Replace if it shows excessive wear or if damaged.
C.
Assembly
1.
Install the blower onto the mount. Install the fasteners and torque.
2.
Connect the blower hose to the blower.
3.
Install the filter assembly.
4.
Install the electric motor to the mount and loosely install the fasteners. Slide the motor toward the blower.
5.
Install the sheaves according to the instructions in Section 3-5-14.
6.
Install the drive belt and adjust the tension on the belt so that it does not deflect more than 1/4".
7.
Tighten the fasteners holding the electric motor.
8.
The ground strap must be reinstalled to the motor.
9.
Connect the wiring in the junction box following the markings made at disassembly.
10.
Install the drive guard.
11.
Remove padlock from the breaker and turn breaker on.
page 3-797
