TM 5-3895-374-24-2C. Assembly1.Mount the eight bearings onto the housing.2.Assemble a control rod into the housing and a fan outlet louver. Install the spring pins.3.Position the rod and the louver so that the louver can turn freely in the housing. The louver should be centeredbetween the two side walls. Tighten the lock collars on the two bearings supporting this rod. This will prevent therod from moving in or out.4.Repeat this for the other rods and louvers.5.Connect the linkage for the control arms and install the spring pins.6.Place the exhaust louver gasket onto the flange on the blower housing.7.Install the louver housing assembly onto the blower housing and install and tighten the fasteners.8.Install the exhaust stack gasket and the stack. Install the fasteners and tighten.9.Install the damper actuator and the two pins that retain it. If there were clamps holding the electrical cable, theyshould be re-installed.10.Plug the electrical cable into the receptacle on the control van.3-5-5 Exhaust Inlet AssemblyRemoval, Repair and Replacement See figure 3-28.This procedure assumes a complete removal, repair and replacement of the assembly. A partial disassembly repair andreplacement is possible. Follow the procedure to the point of removing only those components requiring repair orreplacement.A. Disassembly1.Disconnect and lock out the breaker for the exhaust blower motor.2.Remove the two air lines to the cylinder. Mark the shaft end line so that it is reinstalled at the shaft end. Removethe fasteners that hold the solenoid valve in place. Set the solenoid valve and hoses to the side.page 3 - 772
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
