TM 5-3895-374-24-1
Fig. 10 -Schematic representation of a burner heavy oil manifold.
Also shown, an oil line heater, typically used in heavy oil heavy oil systems.
M. FUEL OIL ATOMIZER
The position of the fuel oil atomizer affects its ability to atomize the oil.
The atomizer should be positioned as shown in fig. 11.
To change the fuel oil atomizer position:
1.
Shut the oil valve upstream of the shutoff solenoids.
2.
Disconnect the Burner Atomizer Assembly from the oil manifold, using the union located downstream of the
flexible hose.
3.
Note the present orientation of the atomizere while assembled in the - burner. Determine if the atomizer must be
retracted into the primary tube or extended out of it. (See fig. 11)
(page 3-515)