TM 5-3895-374-10options ..............utilities........... calibration .......meters ............................................................. Aggregate Scales by Sample<8><6><5><4>Calibration of the Aggregate Scales by weighed load Sample is one of the procedures that cannotbe run while makingmix. On selecting this procedure the WARNING display shown in Figure 8654.0 will be shown. Note that even though thiswarning is displayed, the plant operation and data gathering continues uninterrupted.The Continuation Options are:OPTIONKEYDESCRIPTIONESCapeESCReturn to the previous display.There has been and will be no interruptingof plant operation.(Access).00Interrupts plant operation. Diverts A/C.Gain access to the aggregate scalecalibration procedure displayed in Figure8654.1The calibration display of Figure 8654.1 is a single form containing all the information necessary to calibrate the virgin (orrecycle) conveyor scale by weighed loads.The upper left portion of the display shows the TestParameters. The desired combination of bins that will run during thistest is specified by the parameter MIX #. The rate at which the scale will be calibrated is determined by the rate parametershown in dTPH. The length of time the feeders will run can be preset with the time interval parameter shown in seconds.The MeasuredScaleValues are displayed in the lower left portion of the display. These are the totalizer displays ofinstantaneous rate and accumulated wet tons.The actual procedure is defined by the continuation options in the order shown.The Continuation Options are:OPTIONKEYDESCRIPTIONESCapeESCReturn to the previous display.Parameters4Enter Test Parameter data.Clear.00Clear all totals.Start Test7Run the selected Mix.Correct Totals8Enter recalibration data.page F - 77SYSTEMS Equipment Corp. 8/31/89 Page (40)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
