TM 5-3895-374-10The remaining operator’s controls are displayed on the monitor. Access to input information to the monitor is provided by akeyboard. The monitor prompts the operator for input data or for data required to be displayed. The operator initiates theactivity by pressing "ESC", the (escape) key on the keyboard. The monitor and keyboard are components of the BlendingController. Additional operating instructions are contained in section III, Operating Procedures and in appendix F, BlendingControls.A printer is included to provide a hard copy record of the operation of the plant. It provides a production rate record,information on the quality of the mix and a raw materiel usage record. Additional information on the operation of the printeris contained in appendix F, Blending Controls and in the Maintenance manual.2-10 Training ModeThe MO81 Asphalt Mixing Plant controls have an operator training mode. To access this training mode proceed as follows:ItemProcedure1Provide electrical power to MCC #2. See section 2-8.2Feeder panel-turn Powerkey to the ON position.3Feeder panel lower cabinet-open door to access the Data Table AccessModule (DTAM).4DTAM panel-PRESS F(9). This accesses the control configuration.5DTAM panel-PRESS 9123. This is the training code.6The control panel is now in the training mode. Proceed with plant trainingoperation. See sections 2-13, 2-14, 2-15, 2-16, 2-17, 2-18 and 2-19.To exit the training mode proceed as follows:ItemProcedure1Feeder panel lower cabinet-open door to access the DTAM.2DTAM panel-PRESS F(9). This accesses the control configuration.3DTAM panel-PRESS 0011. This is the operation code.Page 2-85
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
