• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Air Cylinder Repair and Re-assembly - TM-5-3895-374-24-2_142
Figure 3-29 Air Cylinder

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  107    108    109    110    111  112  113    114    115    116    117  
TM 5-3895-374-24-2 4. Inspect the inside of the cylinder barrel for scars, wear or rust.  Thoroughly clean.  It should not be necessary to replace the cylinder barrel unless there has been contamination in the system.  If the barrel is damaged internally, replace if necessary and check the complete pneumatic system for causes of the contamination. C.  Assembly 1. All parts should be lubricated with a good quality, clean lubricant prior to replacing. 2. Install the seals onto the piston. 3. Insert the piston and piston rod into the barrel. 4. Install the seals into the head. 5. Carefully slide the head onto the piston rod butting it up to the barrel evenly. 6. Install and tighten the tie rod nuts. 7. Install the clevis (and jam nut if one is used) and tighten on the piston rod. 8. Plug the ports on the cylinder and re-install on the equipment.  Remove the plugs and connect the air lines. page 3 - 777







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.