• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assembly - TM-5-3895-374-24-2_141
Assembly - TM-5-3895-374-24-2_143

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  106    107    108    109    110  111  112    113    114    115    116  
TM 5-3895-374-24-2 11. Connect the wiring to the limit switch. 13. Re-install the exhaust elbow onto the housing and to the ducting. 14. Inspect all components that have been re-installed.  Confirm that all fasteners have been torqued. 15. Remove padlock from the breaker and turn breaker on. 3-5-6  Air Cylinder Repair and Re-assembly.  See figure 3-29 A.  Disassembly 1. Remove   the   air   cylinder   from   the   installation.      Disconnect   air   hose   lines   and   cap   hose   ports   to   prevent contamination from entering the system. 2. Clean the external parts of the cylinder. 3. Remove the clevis (and jam nut if there is one) from the piston rod.  Use a wrench on the piston rod flat so that the rod is not damaged. 4. Remove the four nuts on the tie rods at the rod end of the cylinder. 5. Slide the head assembly off the piston rod. 6. The piston rod and piston can be removed from the cylinder. 7. Review the complete procedure before continuing.  Using a small screw driver, remove all seals in the head and on the piston. B.  Inspection 1. Replace all seals in the cylinder if they are available.  If not, inspect the seals prior to removal.  Replace seals with cuts, breaks or that are worn. 2. Thoroughly  clean  all  the  components.    Use  care  not  to  damage  or  scratch  any  finished  or  polished  surface. Carefully clean all cavities and grooves. 3. Inspect the piston rod for damage or wear.  Replace it is believed a good seal cannot be obtained after assembly. page 3 - 776







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.