• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assembly-cont. - TM-5-3895-374-24-1_634
Disassembly - TM-5-3895-374-24-1_636

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  582    583    584    585    586  587  588    589    590    591    592  
TM 5-3895-374-24-1 sag is less than 1", the chain is too tight. If the sag is greater than 1.5", the chain is too loose. 21. Install the conveyor rear gate and the two hinge pins that hold it In place. 22. Install the slat conveyor back panel and the six fasteners that hold It In place. 23. Bolt the inlet grate into place. 24. Close the conveyor top doors and fasten. 25. Using slings and a crane, lift the slat conveyor into position on the chassis. See Figure 3-13. 26. Install the conveyor pivot shaft 27. Connect the air line. 28. Lower  the  drive  motor  power  cable  from  the  stairs  and  re-install  the  clamps  holding  it  to  the  chassis  Wrap  the power cable onto the transport brackets. 29. Re-connect the wiring for the limit switches following the diagram In Section 3-4-13. 30. Inspect the complete assembly to confirm that all components have been properly assembled. 3-4-3 Slat Conveyor Drive Removal, Repair and Replacement See figures 3-15 and 3-16. This procedure assumes a complete removal, repair and replacement of this component. A partial disassembly repair and replacement Is possible. Read this complete procedure prior to beginning Follow those procedures required to remove the components  requiring  repair  or  replacement  Close  Inspection  of  components  prior  to  their  removal  or  disassembly  may eliminate unnecessary work. The drive may be repaired with the conveyor in the operating position or in the transport position. If major components In the drive require repair or replacement a crane will be necessary to remove them to ground level if the work Is carried on while the surge bin is in the operating position. A. Disassembly 1. Disconnect and lock out the breaker for the slat conveyor drive motor. page 3-607







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.