• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-16.  Drive Slinging
Slat Conveyor Gear Reducer

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  587    588    589    590    591  592  593    594    595    596    597  
TM 5-3895-374-24-1 7. Install the large sprocket onto the drive shaft. Tighten the set screws and the jam nuts. 8. Install the small sprocket onto the reducer shaft. Place a straight edge along the side face of the two sprockets and align them. Tighten the set screws and jam nuts on the small sprocket. 9. Install the drive chain. 10. To adjust the tension on the chain, loosen the four bolts on the drive unit base plate assembly. Adjust the lock nuts on  the  two  take  up  rod  assemblies  and  turn  the  take  up  rods  drawing  the  base  plate  assembly  away  from  the conveyor and increasing the tension on the chain. Recheck the sprocket alignment upon completing this process. Adjust the alignment If necessary. 11. Install the outside drive guard. 12. Feed the electric power cable into the junction box on the electric motor and connect the four wires following the markings made at disassembly. Replace the cover onto the junction box Tighten the outside nut on the strain relief so it seals against the power cable Re-install any clamps that were holding the cable in place. 13. Inspect the complete assembly and check to confirm that all fasteners have been torqued. 14. Remove padlock from the breaker and turn breaker on. page 3-612







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.