• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assembly - TM-5-3895-374-24-1_587
Assembly-cont. - TM-5-3895-374-24-1_589

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  535    536    537    538    539  540  541    542    543    544    545  
TM 5-3895-374-24-1 GP322FF 5. Install  the  bearing  adjustment  brackets  that  support  the  idler  shaft  bearings.  Adjust  these  brackets  Inward, evenly, toward the drum, to allow the chain when installed to be loose. 6. Assemble  the  sprocket  and  bearings  onto  the  Idler  shaft  taking  care  to  position  the  fixed  bearing  on  the correct  side.  Assemble  the  bearings  according  to  instructions  in  Section  3-3-13.  Position  the  components according to the drawing of this assembly made earlier. 7. Install the idler shaft assembly onto the bearing adjustment brackets Confirm that the markings placed on this assembly match. Align the idler sprocket with the drum drive sprocket prior to tightening the fasteners. 8. Assemble  the  sprocket  and  bearings  onto  the  drive  shaft  taking  care  to  position  the  fixed  bearing  on  the correct  side  Assemble  the  bearings  according  to  Instructions  in  Section  3-3-13.  Position  the  components according to the drawing of this assembly made earlier. 9. Install the drive assembly onto the supports. Install the fasteners and hand tighten. Align the drive sprocket to the drum sprocket Torque the bearing bolts and recheck the sprocket alignment to confirm that it is correct. 10. Install the drive chain. Do not clean or wash new chain as it may be pre-lubricated by the manufacturer. The chain ends can be easily connected where the chain meshes with the drive sprocket The chain pin is slightly larger  than  the  link  plate  aperture.  Drive  the  pin  In  place  with  a  hammer.  Install  the  pin  lock  and  bend  it  to prevent it from falling out. 11. Install the lower chain guard and the four wedge shaped chain guards under the drum. 12. Install the idler guard complete with the chain oiler assembly Adjust the brush so that It contacts the chain. Fill the oil reservoir and open the valve slightly. Bolt the two slot cover plates into position 13. Install the drive guard on the drive side. Bolt the two slot cover plates onto the guard. 14. Install the shaft mounted torque-arm reducer following the procedure for installation in Section 3-3-5. Add the correct oil to the reducer as necessary. Install the sheave following the instructions in Section 3-3-14. 15. Bolt the electric motor into place on the frame. The ground strap must be reinstalled to the motor. Install the sheave according to the Instructions in Section 3-3-14. (page 3-560)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.