TM 5-3895-374-24-2FEBRUARY 1993INCLINEDSCREWReference drawing no. GA3-20315-J-02, Screw Conveyor AssemblyBolts and silicone sealant are provided for attaching the inclined screw to the transfer screw. Two mounting bracketsare provided which must be welded to the trough for support. Support frames from the brackets to the trailer are byothers.ROTARYAIRLOCKReference drawing no. GA3-20315-J-02, Screw Conveyor AssemblyBolts and silicone sealant are provided for attaching the airlock to the inclined screw. Support frames from the airlockflange to the trailer are by others.SCREWCONVEYOR&AIRCOMPRESSORMOTORS/DRIVESReference drawing no. GA3-20315-J-02, Screw Conveyor AssemblyBelt drives and guards are provided by Griffin. Motors are provided by others. Belts are to be installed followingprocedures described by "Martin -Installation/Tensioning V-Drives", Wire motors to starters in main panel by others.ZEROSPEEDSWITCHESReference drawing no. GA3-20315-J-02, Screw Conveyor AssemblyZero speed switches are provided on the tail shafts of all conveyors and the airlock. They are to be wired to the mainpanel with shielded cable.BAGHOUSEINLETReference drawing no. GA3-20315-J-01, General Arrangement.Bolts and sealant for attaching inlet duct to baghouse are to be provided by others. The inlet duct must be designed toprevent excessive structural or thermal loads on the baghouse inlet.BAGHOUSEOUTLETReference drawing no. GA3-20315-J-01, General Arrangement.Flexible boot, clamps, and sealant for attaching the fan to the baghouse outlet are to be provided by others.page 3 - 686
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
