TM 5-3895-374-24-113.Remove the reducer and the reducer motor scoop from the drive unit base plate assembly. It is held in place byfour bolts.14.Remove the reducer motor scoop from the reducer15.Clean all components thoroughly so that they can be Inspected for wear and/or damageBInspection1.Inspect the #200 chain and the sprockets for wear Replace the complete chain if It appears to be damaged or If asection of it Is damaged or worn. Inspect the sprockets for wear to the teeth. If wear is evident or the teeth arebecoming hook shaped, replace the sprockets.2.Have the electric motor Inspected and tested by a qualified facility Repair or replace as necessary3.Inspect the shaft coupling and replace if necessary.4.Disassemble and inspect the gear reducer according to Section 3-4-45.Inspect the take up rod assemblies for damage and replace If the threads are damaged or If the rods are bent6.Inspect all weldments for damage or cracks and repair or replace as necessary.C.Assembly1.Bolt the reducer motor scoop to the reducer Torque bolts2.Install the shaft coupling according to the instructions in Section 3-4-5.3.Bolt the electric motor to the reducer motor scoop Complete the shaft coupling installation and Install the couplingguard. Connect the ground strap from the motor to the reducer motor scoop4.Install the motor-reducer assembly onto the slat conveyor drive mount Position this assembly toward the verticalportion of this mount so that the chain will be slack when Installed. Install and tighten the four bolts that hold it Inplace.5.Lift the drive assembly (see Figure 3-16) up to the conveyor and bolt it in place. Torque bolts6.Bolt the Inside drive guard in place.page 3-609
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
