TM 5-3895-374-24-1
E-15 Close and secure unit door with the self-retaining
cover screws
E-16 Run control and load wiring per installation
Procedure I-16, page 11
E-17 Perform
pre-operational
check
on
all
new
equipment (Installation Procedure I-17, page 12).
E-18 Follow initial unit maintenance Procedures M-11
through M-37, pages 17-23.
E-19 Close off all openings in motor control center.
E-20 Return motor control center to service See
Procedure 1-18, page 12.
Installing Additional Motor Control Center Sections
WARNING There is a hazard of electrical shock or
burn whenever working in or around electrical
equipment
Turn
off
power
supplying
this
equipment before working on it
E-21 Adding motor control sections is basically the
same as installing a new motor control center.
E-22 Remove the end closing plate from the end of the
existing motor control center where the new
section(s) are to be added Save cover and
hardware for use on the end of the new section(s).
(Page 3-145)
