• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
name of parts - TM-5-3895-374-24P_545
assembly parts

TM-5-3895-374-24P M081 Asphalt Mixing Plant Manual
Page Navigation
  530    531    532    533    534  535  536    537    538    539    540  
TM 5-3895-374-24P ORDERING PARTS: When ordering parts for reducer specify reducer size  number,  reducer  serial  number,  part  name,  part number and quantity. It is strongly recommended that when a pinion or gear   is   replaced,   the   mating   gear   or   pinion   also   be replaced. If  the  large  gear  on  the  output  hub  must  be replaced,    it    is    recommended    that    an    output    hub assembly  of  a  gear  assembled  on  a  hub  be  ordered  to secure  undamaged  surfaces  on  the  output  hub  where the oil seals rub. How- ever, if it is desired to use the old output hub, press the gear and bearing off and examine the   rubbing   surface   under   the   oil   seal   carefully   for possible  scratching  or  other  damage  resulting  from  the pressing  operation.  To  prevent  oil  leakage  at  the  oil seals, the smooth surface of the output hub must not be damaged. If  any  parts  must  be  pressed  from  a  shaft  or from the output hub, this should be done before ordering parts  to  make  sure  that  none  of  the  bearings  or  other parts  are  damaged  in  removal.  Do  not  press  against outer race of any bearing. Because old shaft oil seals may be damaged in disassembly  it  is  advisable  to  order  replacements  for these parts. page C6 - 9







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.