• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-88.  Hydraulic Leveling System
Figure 3-89.  Hydraulic Cylinder

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  685    686    687    688    689  690  691    692    693    694    695  
TM 5-3895-374-24-2 B.    Inspection 1. Clean the components.  Inspect internal tube and chrome rod for gouges, scratches or wear. 2. Replace components that are damaged. 3. Replace all seals. C. Assembly 1. Lubricate the o-rings and seals prior to installation. 2. Install the piston seals onto the piston. 3. Install the seals into the cylinder head. 4. Install cylinder shaft spacer tube, if required, onto shaft. 5. Lubricate the bore of the cylinder head and slide it onto the cylinder shaft. 6. Lubricate the piston, seals and cylinder bore and install piston and shaft into the cylinder. 7. Using  the  face  spanner  wrench  tighten  the  cylinder  head  into  the  cylinder  tube  until  the  outer  face  of  the cylinder head is flush with the end of the cylinder tube. 8. Install the hydraulic cylinder onto the equipment and connect the hoses. 9. Upon installation of the cylinder, completely extend and retract the cylinder under no load several times to allow trapped air to escape through to the reservoir. page 3 - 1388







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.