• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-61  Feeder Flow Switch Position
Figure 3-62 Belt Feeder

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  606    607    608    609    610  611  612    613    614    615    616  
TM 5-3895-374-24-2 5. Inspect the brackets and replace if they are damaged. C. Assembly 1. Install the stop arm onto the stop arm bracket and tighten the bolts. 2. Slide the stop arm bracket onto the center of the shaft and tighten the bolt and nut. 3. Bolt the two flange bearings to the two brackets. 4. Slide the bracket and bearings onto the shaft and place this assembly onto the feeder housing.  Bolt the brackets into place and center the shaft in the bearings.  Tighten the bearing lock collars. 5. Install the counter weight onto the shaft and position according to figure 3-61. 6. Install the cam onto the shaft and position according to figure 3-61.  Tighten the set screw. 7. Check  the  location  of  each  of  the  components  as  shown  in  figure  3-61.    Adjust  as  required  to  assure  proper operation of the switch. 8. Connect the wiring to the limit switch following the markings made at disassembly. 9. Disconnect and lock out the breakers for the screen drive motor and the conveyor motor. 3-9-5 Belt Feeder Removal, Repair and Replacement See figure 3-62. This procedure assumes a complete removal, repair and replacement of the assembly.  A partial disassembly, repair and replacement  is  possible.    Follow  the  procedure  to  the  point  of  removing  only  those  components  requiring  repair  or replacement.  The procedure is the same for all four of the belt feeders. A. Disassembly 1. Disconnect and lock out the breaker for the feeder drive motor and the gathering conveyor motor. page 3 - 1309







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.