• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Screen Deck Removal, Repair and Replacement
Assembly - TM-5-3895-374-24-2_607

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  541    542    543    544    545  546  547    548    549    550    551  
TM 5-3895-374-24-2 11. Remove the two offset weight pulleys (21) from the shaft.  See the instructions for the bushings at the end of this section. 12. Disconnect  the  grease  line  (16)  to  the  seal  retainer  plate  (14).    The  seal  retainer  plates  (14)  are  removed  by removing the fasteners holding them.  Slide the plate and the seal (13) off the screen shaft. 13. The bearing (12) is pressed into a bearing housing (6).  Remove the bolts in the flange of the bearing housing (6). Use  a  puller  on  the  bearing  housing  flange  (6)  to  remove  it  from  the  screen  deck  side  plate  (1)  and  the  shaft housing (2).  Slide the assembly off the shaft.  Repeat this for the opposite side. 14. Use a puller to remove the bearing (12) from the housing (6). 15. Remove the seal (11) from the housing (6). 16. The shaft (10) can be removed from the shaft housing (2). 17. If necessary, the shaft housing (2) can be removed from the screen frame (1). 18. The screen cloth (33) is held in place with two clamps (34).  Remove the carriage bolts holding the clamps (34) in place and remove both the clamps (34) and the cloth (33). 19. The screen cloth (33) is supported on three deck channel rubbers (32).  These rubber strips  have  a  channel  or groove on the back which permits them to be pushed onto a flat piece of steel.  They should be removed only if they are going to be replaced. 20. Clean all components. B. Inspection 1. Inspect  the  screen  clamps  (34).    If  they  are  worn,  replace  them.    The  carriage  bolts  should  be  replaced  at  the same time. 2. Replace the screen cloth (33) if the cloth is worn through or damaged. 3. The deck channel rubbers (32) will wear if the screen cloth (33) was not tight.  Replace the rubbers (32) with new ones if they show considerable wear. 4. Inspect the screen shaft (10).  The bearing and seal surfaces should be smooth and not worn.  Check the shaft (10) to determine if it is straight and replace if it is not. page 3-1240







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.