• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENTERING CALIBRATION PROGRAM
SETTING THE DISPLAYED UNITS

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  420    421    422    423    424  425  426    427    428    429    430  
TM 5-3895-374-24-2 955-257 6.4 PART NUMBER CHANGES The following list defines allowable part number changes for the part number table shown above. DIGIT (1) : Any number change requires a hardware change too. DIGIT (2) : Numbers 1, 2, 3, 4 are interchangeable by keypad instruction. Numbers 5 and 6 are interchangeable by keypad instruction. Numbers 7 and 8 are interchangeable by keypad instruction. Any other change requires a hardware change too. DIGIT (3) : Numbers 1, 2, 4 are interchangeable by keypad instructions only. Any other changes require a hardware change too. DIGIT (4) : Numbers OD thru 12 are interchangeable by keypad instructions. Any other changes require a hardware change too. DIGIT (5) : All numbers except 0 are interchangeable by keypad instruction. DIGIT (6) : All numbers except 0 are interchangeable by keypad instruction. DIGIT (7) : This number is used to identify specials and should only be changed by authorized personnel. Most recalibration requirements will use the original part number found on the instrument labels.  If you make a change in the PART NUMBER, be sure you write the new number down on the back cover of this manual for future reference.  If you do not need to reset or change the part number push, the PARAM DISPLAY key to advance the display and proceed to paragraph 6.6. If you do want to change the part number, proceed with paragraph 6.5. ECLIPSE INSTRUMENTATION DIVISION (page 3 - 1118)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.