• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assembly of trolley - TM-5-3895-374-24-2_241
Precautions to be taken in operation

TM-5-3895-374-24-2 M081 Asphalt Mixing Plant Manual
Page Navigation
  202    203    204    205    206  207  208    209    210    211    212  
TM 5-3895-374-24-2 Table 1 3.  Mounting of trolley on beam 1)    Adjustment of trolley width before mounting. Make adjustments as follows for a proper clearance, with the trolley connected to the electric or manual chain hoist. Adjustment of A dimension Proper A dimension is beam width (B) + about 4mm. Make adjustment by adding or taking out the outer spacers, without caring about the number of spacers shown in Table 1. Adjustment of C dimension Proper C dimension is about 7-13 mm for ½ton to 3ton and 9-15 mm for 5 ton capacity.  Make adjustments by adding or taking out the inner spacers on side plate SN side, without caring about the number of spacers shown in Table 1.  There is a difference of spacer between the right and left side.  However, this does not pose any problem.  Minimum one piece of spacer is required on both sides. After adjustment, securely insert the split pin into the shaft stopper pin and bend securely both branches of the split pin. Fig. 2 (page 3 - 876)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.