• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TRUNNION ALIGNMENT-cont.
Asphalt/Fines Injection Pipes

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  555    556    557    558    559  560  561    562    563    564    565  
TM 5-3895-374-24-1 3-3-10   Drum Flight Removal and Replacement.  See figure 3-8. A Removal 1. Disconnect and lock out the breaker for the drum drive motor and the burner blower motor. 2. Obtain  the  required  approval  to  enter  the  drum.(A  confined  space).    Test  the  air  quality  for  the  presence  of dangerous gases.  Ventilate the drum with sufficient air to allow work to be carried out Inside the drum safely. 3. Clean out the drum Interior. B. Replacement 1. The drum flights are removed by removing the fasteners that hold them In place.  After operating the drum these fasteners are best removed by cutting the heads off the bolts Remove the flight from the drum. 2. Install the new flight into the same position as the previous one.  Install and torque new fasteners. 3 The  drum  discharge  flights  are  adjustable  on  the  fasteners.    Position  these  flights  to  within  1/8”  to  ¼”  of  the discharge wear plate. 4. Remove padlock from the breaker and turn breaker on. 3-3-11   Drum Seals Removal and Replacement.  See figure 3-9. A. Removal 1. Disconnect and lock out the breaker for the drum drive motor. 2. Remove fasteners holding the eight seal clamps in place. 3. Remove seal clamps and drum discharge seal. 4. Clean the seal clamps, drum surface and mounting areas. B.    Replacement 1.  Install the new drum seal, clamp and fasteners.  Torque bolts as required page 3-580







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.