• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Joining Sections - TM-5-3895-374-24-1_152
Positioning and Splicing

TM-5-3895-374-24-1 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  108    109    110    111    112  113  114    115    116    117    118  
TM 5-3895-374-24-1 I-11 Connecting the shipping section is easily accomplished  by  using  the  following  appropriate procedure I-11A 15" (381 mm) DEEP FRONT-OF-BOARD SECTIONS There are eight tie points used to fasten the motor control sections together. Remove all of the units in Section R, leaving only the unit support pans in place This allows access to the four rear tie points The front four tie points are accessible from inside the vertical wire trough In Section L. Fasten the sections together by using a /4" - 20 x 5-’bolt and 1/4 " lock washer at each of the eight tie points. The bolts engage cage nuts furnished on the structure. I-11 B    20"    (508    mm)    DEEP    FRONT-OF-BOARD SECTIONS.  There  are  eight  be  points  used  to fasten the motor control sections together. The   front   four   be   points   are   accessible   from inside  the  vertical  wire  trough  in  Section  L  The rear  four  tie  points  are  accessible  from  the  rear of the motor control center by removing the back plates of Section L. Fasten the sections together by using a 1/4" - 20 x  5/8  bolt  and  1/4"  lock  washer  at  each  of  the eight   be   points   The   bolts   engage   cage   nuts furnished on the structure NOTE If the rear of Section L is accessible, use instructions  for  a  15"  (381  mm)  DEEP  FRONT- OF-BOARD SECTION (I-11 A) I-11C 20" (508 mm) DEEP BACK-TO-BACK SECTIONS.  There  are  eight  be  points  used  to fasten the motor control sections together. The   front   four   be   points   are   accessible   from inside  the  front  vertical  wire  trough  in  Section  L The   rear   four   tie   points   are   accessible   from inside the rear vertical wire trough in Section R. Fasten the sections together by using a 1/4" - 20 x  5/8"  bolt  and  1/4"  lock  washer  at  each  of  the eight   be   points   The   bolts   engage   cage   nuts furnished on the structure. (Page 3-125)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.