• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Feed Conveyor Set Up Procedures - TM-5-3895-374-10_71
Figure 2-20 Dedrummer/Melter

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  57    58    59    60    61  62  63    64    65    66    67  
TM 5-3895-374-10 Item Procedure 10 Lower the trailer on the hydraulic jacks until the trailer is resting on the front screw jacks. The landing jacks will slide up while the chassis is being lowered. 11 Check the trailer for level from side to side at both front and rear. 12 Adjust screw leveling jacks as necessary to obtain level indication. Raise and lower with hydraulic jacks. 13 Remove the two pins holding the telescoping section of the feed conveyor and retract the hydraulic cylinder until the center pin holes in the conveyor support structure are in line.  Install  the  pins.  The  conveyor feed chute should now be directly over the drum mixer inlet chute. 14 Lower the feed conveyor into operating position. This is accomplished when the pin holes are in line with the pin holes on the conveyor support structure. 15 Position the hydraulic power pack and connect the two hoses to lift jack valves. 16 Install the pins. Use the pins removed from the storage position. 17 Raise the hydraulic legs. 18 Unbolt the top bolts in the four red transport plates of the screen deck.  Rotate the red plate 450 and re-install bolts. Remove the two transport braces on the conveyor belt counter  weight. page 2 - 38







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.