• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2-15 Exhaust Ducting
Figure 2-16 Baghouse

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  49    50    51    52    53  54  55    56    57    58    59  
TM 5-3895-374-10 7 . Baghouse Set Up Procedures (See Figures 2-1, 2-15 and 2-16) Stake the Baghouse left hand front and rear corners according to Figure 2-1. Site along the Drum Mixer to keep the units in line. Use surveyors tape or colored rope between the two stakes. Back the Baghouse into position. Item Procedure 1 Remove  the  duct  elbow  section  from  the  200  kW  generator  trailer  and  install  it  onto  the  baghouse shutter  door housing. Check the seal, install and tighten all the bolts. 2 Position the baghouse according to the site layout. Locate in line with drum mixer backing up unit until the drum duct and baghouse ductflanges meet. Install the bolts. 3 Disconnect the baghouse from the transport tractor. 4 Connect the hydraulic power pack. 5 Use the hydraulic leveling jacks to raise the baghouse. 6 Lower the four screw jacks and install pads. 7 Extend the screw jacks. 8 Retract the leveling jacks until the baghouse is supported on the screw jacks. 9 Check the chassis to see that it is level side to side and front to back. 10 If adjustment is required use the leveling jacks to raise the chassis and adjust the screw jacks as required. 11 Retract the leveling jacks. 12 Disconnect the hydraulic power pack. 13 Remove the stack from the transport position and install it onto the exhaust outlet. Check the seal and then connect with bolts. 14 Position the handrail and ladders into the operating position page 2 - 30







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.