• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Surge Bin Set Up Procedures - TM-5-3895-374-10_51
Surge Bin Set Up Procedures - TM-5-3895-374-10_53

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  37    38    39    40    41  42  43    44    45    46    47  
TM 5-3895-374-10 Item Procedure 29 Start the hydraulic pump on the surge bin. 30 Remove the two conveyor support pins from their location at the rear of the chassis.  Remove the two telescoping conveyor support structure pins. 31 Using the left side hydraulic control valve lever extend the conveyor lift cylinders by pulling the lever. 32 The conveyor will slowly pivot around its support and raise into the operating position. 33 Re-insert the two conveyor support pins at the rear of the chassis. 34 Insert the pins into the upper telescoping conveyor support structure on each side. 35 Install the platform handrail. 36 Remove the four corner pins holding the bin legs to the support structure by using the hydraulics to remove the weight from the pins. 37 Raise the bin by operating the center and right control valve levers simultaneously.  Carefully observe the cylinder extension to ensure that the bin is going up equally at all four corners. 38 When the bin has been raised to the operating height re-insert the four corner pins. 39 Lower the bin slightly so that the weight of the bin rests on the support pins and not on the hydraulic cylinders. 40 Shut off the hydraulic pump on the surge bin. 41 Position the conveyor stairs and handrail on the conveyor. 42 Close the front and rear bin doors. 43 Fold down the ladders. 44 Remove the bolts holding the bypass chute in the transport position on the platform. 45 Use a crane to lift,  position and lower the bypass chute over the slide chute. 46 Bolt the two chutes together. 47 Remove the transport bolt at the bottom of the slide chute.  This permits the chute to pivot back into the operating position. page 2-18







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.